Basement Waterproofing Before & After Photos

This unfinished basement in Shrewsbury, MA was in need of some assistance when it came to keeping dry. After years of dealing with water coming in, and constant dampness that lead to mold growth - these homeowners were ready to take action. With a full perimeter WaterGuard system in place and a TripleSafe sump pump rounding out the installation - they can rest assured water troubles are a thing of their past!

Above are before and after photos of a crack. We utilized our Flexispan crack repair system. We had previously done work for this homeowner, and he recently noticed a crack in his basement wall. The crack was leaking water into his basement and he knew that DryZone Basement Systems was who he should call.

Our inspector went to the home to take a look at the crack and determined we could use our Flexispan system to seal it. Our team went out and filled the crack from top to bottom with our special Flexispan sealent.

Flexispan differs from other crack fillers or sealents in two major ways. First, Flexispan eliminates the use of messy expoxy injections and instead seals the crack with a flexible sealent that will stop water seeping through the crack. The other key factor in our Flexispan system is that it doesn't end with sealent. Our system uses an additional step to make sure that no seepage will make it pass the sealent. A second layer of  beveled foam is used, which would drain any small amount of additional seepage down into your drainage system or into a small drywell created under the basement floor. 

A homeowner in Shrewsbury, MA was having problems with water getting into their finished basement. Our inspector, James, drew up a solution to waterproof the basement with our products that include the WaterGuard drainage system, TripleSafe sump pump, SaniDry Sedona dehumidifier, and CleanSpace wall system. These products were installed by our crew, lead by our foreman Carlos, and work together to protect the basement from water. The four products mentioned are all installed inside of the basement to keep water out, but what happens to that water being pushed out? It still needs somewhere to go right? That's where the IceGuard discharge line system comes in. IceGuard is installed on the outside of the home to prevent water from seeping back into the basement in the event of a clogged or frozen discharge line. IceGuard provides an escape route. Water escapes from the IceGuard fitting only when the discharge line becomes clogged. Otherwise, water flows past the slotted openings into the drain pipe. Although it's a small product, it makes a world of difference when it comes to keeping your basement completely waterproof. With James's solution installed by Carlos and his crew, this homeowner can refinish their basement and not have to worry about water getting in ever again!

This basement in North Grafton, MA was not staying dry, even with a sump pump. The main issue was the sump pump itself actually, it was old and did not receive any type of cleaning within the past several years! This homeowner needed a new solution, and we delivered! Our production team swapped out the old sump pump and installed our TripleSafe sump pump, equipped with 3 pumps for more pumping power to fight against heavy rains and power outages. As the cherry on top, we plugged in our SaniDry Sedona dehumidifier to dry out the humid air, improving the air quality in this basement for years to come! 

This homeowner in North Grafton, MA was experiencing constant water seepage through his basement walls, resulting in a mess! Puddles everywhere and the area felt very humid. His sump pump was not doing the job, so we installed our TripleSafe sump pump to provide better protection against the seepage which will prevent floods. Additionally, we installed a SaniDry Sedona dehumidifier to lower the humidity and decrease the risk of mold growth and musty odors.